![]() Run the display interface ] command to view traffic information of the specified interface. Traffic-policy flow-limit outbound //Apply the traffic policy to the interface. Specify an interface according to your actual situation. ![]() In this example, the inbound interface is Eth-Trunk 1. Interface Eth-trunk 1 //Enter the view of the inbound interface of high-bandwidth traffic. Traffic-policy flow-limit //Configure a traffic policy named flow-limit.Ĭlassifier flow-limit behavior flow-limit //Associate the traffic classifier with the traffic behavior in the traffic policy. ![]() ![]() Set these values according to your actual situation. In this example, the values of CIR and PIR are 10 kbit/s. Traffic behavior flow-limit //Configure a traffic behavior named flow-limit.Ĭar cir 10 pir 10 green pass yellow discard red discard //Limit the traffic rate. If-match acl name flow-limit //Specify the ACL named flow-limit. Traffic classifier flow-limit operator or //Configure a traffic classifier named flow-limit. Rule 5 permit ip source 10.1.1.1 0 destination 10.2.1.1 0 //Match traffic with the source IP address of 10.2.1.1 and the destination IP address of 10.1.1.1 Configure an advanced ACL on PE1 to match high-bandwidth traffic.Īcl name flow-limit advance //Configure an advanced ACL named flow-limit to match high-bandwidth traffic.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |